Subaru

Home / Subaru / Page 4

We Service and Repair all Subaru cars

  • 2012 Subaru Outback

    Subaru Outback
    Mileage
    126,078
    Service Date
    8/7/2021
    Services Performed
    • Scanned faults and found same solenoid fault stored as last time. Recommend replacing valve body.
    • Replaced valve body and refilled transmission with new fluid. Test drove for 30mi with no issue over 3 different drives. Transmission shifts smoothly and no CEL after test drives.
     
    David K. gave our service a 5 star review on 8/20/2021
  • 2016 Subaru Forester

    Subaru Forester
    Mileage
    76,658
    Service Date
    7/31/2021
    Services Performed
    • Changed engine oil and filter. Oil was at bottom of dipstick o/a – recommend more frequent oil level checks. Slight weap of oil near crank seal and on DS head gasket – Monitor at next oil service. Lower rearward control arm bushings cracking. Tires had more wear on front tires – rotated front to back. Set tires pressure to 35psi all 4 and torqued wheel lug nuts to spec (all 4). No codes stores, belts OK, suspension OK, Exhaust OK, Drivetrain OK
     
    Janine B. gave our service a 5 star review on 7/31/2021
  • 2017 Subaru WRX

    Subaru WRX
    Mileage
    144,721
    Service Date
    7/23/2021
    Services Performed
    • Found fault in history: P2097 – rear O2 sensor, rich. Monitored O2 sensor data – with engine at full operating temp rear sensor stays at .8v regardless of engine speed, front sensor (AF sensor) stays between 1.01v and 1.03v indicating a faulty front sensor. Fuel pressure tests okay, mass air and intake air temp within spec. Re-checked wiring for O2 sensors – all okay. Rear sensor seems to be functioning as designed indicating catalytic converter is operating as designed. Noticed high engine vacuum during a hot idle. Suspect front sensor is failing and possible PCV issue. Replaced front A/F sensor. Cleared fault and road tested while monitoring sensor data. Both sensors are now reading correctly and no faults set. Put over 45mi on test drives, no fault code returned.
    • Changed engine oil and filter – used 4.5L 5w30 synthetic. **Level was correct before draining**
     
    Genevieve G. gave our service a 5 star review on 7/23/2021